You can alternatively use your own path rather than c:\foo. Then from command prompt type the following command So to make it work I followed these steps.Įxtract the Jungo Installer from Studio. But am pretty sure that the Jungo USB driver just launches the wdreg.exe tool to install the drivers internally. I installed/uninstalled the Jungo driver many times, but hardly able to notice whether it succeeded or failed. If you see AVRISP mkII there, then youll need to. So as far as know, I interpreted the symptoms to be a problem with the Jungo USB driver. Go into your Device Manager and expand the tree under Jungo. In Studio 5 programming dialog, am able to see it’s id and if I select the interface as “JTAG” and click “Apply” it throws error “Unable to connect to tool”. Tools Firmware Upgrade in Studio 5 : Didn’t find it though. Gets enumerated as USB device : Yes it does, I am able to see it in the programming dialog of studio 5. Shows up in Device Manager : YES, but with a yellow warning icon. My STK 600 was not detected either by Studio 5.0 or Studio 4 or even by stk600.exe. So I started to dig this out and see if I can fix things myself and I am pretty much pleased that I was able to make it work. Though there are a lot of beautiful that can happen for a typical Friday night, but am in middle of a STK 600, a Dell Latitude with Windows 7 X64 and a broken connection between these two. Now it’s around 2 AM in the morning, ouch its 2 AM midnight actually.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |